![]() ![]() Open protocols (such as RSH and Telnet) are disabled by default. NOTE: In Data ONTAP 8.0 7-Mode, only secured protocols (such as SSH) are enabled by default. – The options dns.enable on command enable Domain Name System (DNS) name resolution (which requires further configuration). ![]() – The cifs shares –add … command defines a CIFS share. – The aggr status command displays the existing aggregates. Command-line interface: accessed via Telnet, Remote Shell (RSH), or Secure Shell (SSH) NetApp System Manager: a GUI designed for single-system configurationĢ. The administration of the NetApp FAS controller can be performed via various administrative interfaces.ġ. Related Article: Netapp Interview Questions NOTE: Similar initiator-target relationships exist in iSCSI connections. The fcp show initiator command returns all host FC initiator ports that are visible via the controller‘s FC target ports.įigure 4: Fibre Channel Initiator-Target Port Relationships The fcp show adapter command returns only the FC ports that are configured to function in target mode. Any FC HBA adapter that you purchase is predefined as either an initiator or target adapter. NOTE: The fcadmin command applies only to the built-in FC ports. The built-in FC ports can function in one of two modes: You may also need to configure the built-in FC ports (located on the motherboard). To enable persistence after a reboot, you must enter the changes into the /etc/rc file. NOTE: Most changes made from the command-line interface are transient. #NES APP SWITCH PROFESSIONAL#To manually reconfigure the FAS controller‘s Ethernet network interfaces, you use the NetApp System Manager interface or the ifconfig command for example ifconfig ns0 192.168.1.1 netmask 255.255.255.0 Do you want to become a professional in this domain? Then Enroll in Netapp Online TrainingThis course will help you to achieve excellence in this domain. You can rerun the setup script manually at any time to reconfigure the parameters. This script configures fundamental parameters such as hostname, network IP addresses, and CIFS authentication (if licensed). When the storage controller is powered on for the first time, it runs the setup script. For brevity, some protocols, such as the NetApp API (Manage ONTAP Solution or ZAPI), and Network Information Service (NIS) are not shown. NOTE: This figure identifies only the major storage, management, and authentication protocols. Refer to Figures 3 for the identification of the supported protocols.įigure 3 – Protocols supported by the Netapp FAS Controllers #NES APP SWITCH SOFTWARE#The NetApp FAS storage controllers are designed around the NetApp Unified Storage architecture and support numerous storage protocols, software features, and storage tiers in an appliance-like design. Data ONTAP is the foundation of the NetApp Unified Storage architecture, supporting a wide range of storage protocols and storage-management software features. The operating system of the NetApp FAS storage controller is named Data ONTAP. Netapp Tutorial For Beginners In this Netapp Tutorial, you will learn below topics If you are looking for a Netapps tutorial you are at the right place our in-depth tutorial covers all the topics you need to know. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |